It sounds like you may have something like the Jensen RV Stereo # JWM20.
If that's the case, to set the time you'll want to:
1.Press and hold the TIME button.
2.Press the TIME button repeatedly until the CLOCK SET menu pops up.
3.The hour and minutes will flash, you can use buttons 11 (skip ahead button) or 12 (skip back button) to increase or decrease the minutes/hours.
I have also included the cutout from the instructions that also shows these instructions. view full answer...
If you are referring to the 12 volt pin that is located in the 1 o'clock position on the 7-way trailer connector then there should be 12 volt power feeding from the vehicle to the trailer on that pin. This means that if you test the 12 volt wire (usually black) before it enters and exits the controller, there should be 12 volts on either side assuming the 12 volt wire on the trailer is ran to a battery for maintenance changing purposes. Attaching two 12 volt power wires together will not... view full answer...
If you are using the Single-Axle Trailer Hanger Kit part # APS3 with the 3-Leaf Double-Eye Spring part # e59SR then you will need to install the leaf springs hangers 22-7/8" apart. In regards to spacing front to back, I have attached a help article for you that will help with this. view full answer...
No you cannot replace the front clamps of the Extang Trifecta 2.0 Soft Tonneau Cover # EX92430 with the Replacement Tail Clamp Assembly # EX31003005. The front and tail clamps are different in order to keep the tonneau cover securely in place and thus not interchangeable. view full answer...
Go To Results